Upgrade Firmware - Ness EDR1640 Instruction Manual

9. Upgrade Firmware

This chapter will try to give you a detailed instruction on how to upgrade the DVR. This
will be helpful in completing the upgrading process.
Please go to
"Product Firmware Upgrades". Then click on the folder that represents you're the
model number of your DVR.
Copy the .ETW to your USB memory from your computer
Insert the USB in to the USB slot on the front panel of the DVR. When inserting the
USB, make sure the direction of insertion is correct.
If you are in Record mode hit the stop button to stop recording.
If the menu pops up when you press the stop button. This usually means you have
either the DVR is in Timer record or Motion record. Log into the DVR menu by pressing the
Menu button. Go to Either Timer Setting Menu or Motion Record Setting menu and turn
them off.
Once you have stopped any type of recording on the DVR you are ready to upgrade.
Press the menu button and use the Jog Dial to go to "System" menu.
Using the enter button to navigate in the menu. Highlight "System Upgrade" turn
NO to YES (use jog wheel to select).
Highlight "YES" again and press "Select" (use jog wheel to select).
Next to System Upgrade you will notice it say "1/3"
Once you have read "success" log out of the menu by pressing the menu button
twice. Then turn the DVR power off and turn it back on.
ftp://208.50.31.200 and go to DVR Firmware upgrade folder
86
Chapter
9