Russell Hobbs Glow Smoothie Maker Instructions And Warranty page 7

3 Turn the jug to align
the jug and base off the motor unit.
4 Remove the lid and cap or stirrer.
Caution
- take great care when handling the blade unit.
5 Remove the blade unit from the base before removing the base from the jug.
6 Turn the jug upside down, so you can see the underside of the blade unit.
7 Hold the jug handle with one hand, hold the underside of the blade unit with the other
hand, and turn the blade unit clockwise to release it – it's quite stiff.
8 Carefully lift the blade unit out of the jug.
9 Keep hold of the jug handle – grip the jug base, and turn it anti-clockwise to release.
10 Lift the seal off the blade unit – mind the blades, they're sharp!
11 Unscrew the tap from the jug base – it takes 2 complete turns to unscrew
12 Unscrew the lever and its retaining ring from the tap – this takes about 2½ turns.
13 Wash the cap, lid, stirrer, tap parts, jug, blade unit, and seal in warm soapy water, and
leave them to drain dry.
14 Don't use a cloth for drying. You may leave lint on the inside surfaces, and you'll
probably cut yourself on the blades.
15 Use a bottle brush on the hole in the jug that the tap fits into.
16 Your bottle-brush may also come in handy when cleaning the inside of the tap.
17 If you've left it too long before cleaning, and bits have glued themselves to the inside of
the jug, use a nylon brush. If that doesn't work, crush some ice cubes in it – that'll shift
anything.
18 Don't put any part of the smoothie maker in a dishwasher.
19 The extreme environment inside the dishwasher can affect the surface finishes.
20 Wipe the outside of the motor unit with a clean damp cloth.
21 Don't put the motor unit in water or any other liquid.
22 Don't use harsh or abrasive cleaning agents or solvents.
Reassembly
23 Wait till everything's dry.
24 Fit the jug base to the jug before replacing the blade unit.
25 Reseat the seal on top of the jug base – this seal is flat, with a ribbed upper surface.
26 Align the q on the glass part of the jug with the open padlock on the top of the jug base.
Jug base.
27 Lower the glass part of the jug into the jug base.
28 Turn the jug to bring the q over the closed padlock on the top of the jug base.
29 The jug must be turned far enough round to allow the safety switch actuator to move
freely. You can see it if you look down into the jug from behind the handle.
30 If you can't move the actuator, you haven't turned the jug far enough round.
31 Replace the seal round the blade unit – keep your fingers clear of the blades.
on the bottom of the jug base with
7
on the motor unit, then lift