System Repacking Instructions - X-Rite EasyTrax Setup And Operation

System Repacking Instructions

Refer to the following instruction to repack your system in the event shipment is required. If the
original carton and supports are not available, contact X-Rite to have a replacement shipped
to your location.
Position the bottom shipping supports labeled #1 through #6 around the inside of the
1.
bottom shipping box. Make sure to include all accessories that were originally shipped.
Note: The small EasyTrax system does not include the #2 and #5 supports.
Using two people, carefully insert the system into the shipping carton with the vertical bar
2.
at the #1 and #4 support end of the carton. Position the vertical arm forward approximately
2" from the left edge of the table so that the end of the arm rests in the channel of the
bottom support #1. Position the read head approximately 2" from the top edge of the table
so that it is secured in place when the top support is installed.
EasyTrax Setup and Operation
Power supply
Paper stops
Magnets
Software CD
Line cord
Ethernet cable
23




Shipping insert


Left edge
Vertical arm
in channel
Top edge