Initial Setup; Manual Color Bar Alignment - X-Rite EasyTrax Setup And Operation

Initial Setup

Initial setup is required the very first time the system is used. The setup includes a manual color bar
alignment and a laser alignment.

Manual Color Bar Alignment

Position the paper stop alignment tabs in the available slots at the bottom edge of the table
1.
to accommodate the sheet size.
Adjust the paper stop alignment tab so that the center point lines up with the middle hash
2.
mark at the base of the paper stop.
Place a press sheet within the instrument's measurable area between the sheet edge
3.
indicators.
Center the read head reticule over the first patch of the color bar that is closest to the home
4.
position as previously explained. This is accomplished by, compressing and holding the two
locking tabs located on both sides of the read head. This causes the read head to lift slightly
off of the table and frees it for up/down (vertical direction) movement.
Locking tab
Locking tab
EasyTrax Setup and Operation
Read head reticule
positioned over 1
10
Middle hash mark
st
patch
Paper stop
alignment tab