Laser Alignment - X-Rite EasyTrax Setup And Operation

Laser Alignment

CAUTION: CLASS 1 LASER PRODUCT
Manually align the color bar following the Manual Color Bar Alignment procedure discussed
1.
earlier.
Position the read head reticule over the first patch on the color bar as previously explained.
2.
Launch the Press Tool application and turn on the laser line by pressing the Laser button on
3.
the read head (the laser automatically turns off after 30 seconds).
•
If the laser line is not centered down the length of the color bar, continue with step 4.
•
If the laser line is centered down the length of the color bar, press the Laser button
again to turn it off. The alignment procedure is not required. You are now ready to
perform color bar measurements.
Laser button
Note: Only continue with these steps if an alignment is required.
4.
If the laser was not aligned, remove the supplied 1.5 mm hex key from its storage
compartment at the back of the vertical arm.
1.5 mm hex key
storage location
EasyTrax Setup and Operation
Laser line along color bar
12