X-Rite EasyTrax Setup And Operation page 15

Adjust the location of the laser line by turning the adjustment screws clockwise or
5.
counterclockwise. Adjust the screws until the laser line is centered down the length of the
color bar. Refer to the illustrations that follow to find the correct adjustment procedure for
your laser.
Back screw
location
When finished with alignment, press the laser button to turn off the laser.
6.
•
Laser line is above the color bar
Turn both adjustment screws in the counterclockwise direction to move the laser line
down onto the color bar.
Front screw
Back screw
•
Laser line is below the color bar
Turn both adjustment screws in the clockwise direction to move the laser line up onto
the color bar.
•
Near side of the laser line is above the color bar
Turn the front adjustment screw in the counterclockwise direction to move the near
side of the laser line down onto the color bar.
EasyTrax Setup and Operation
Front screw
location
13
Laser line
Laser line