Table of Contents
Advertisement
3. Press the
seconds. There will be a six confirmation chirps with 3 long chirps
to confirm the system "Alarm Feature A, B Programming all
returns to factory default setting.
RETURN TO START FEATURE FACTORY DEFAULT SETTING:
Press the
on the transmitter together for 6 seconds. There will be six confirmation
chirps with 3 long chirps and three parking light flashes to confirming the
system " S tart Feature C & D Programming" all return to their factory
default setting.
Exit: Turn the ignition switch "ON" or leave it for 15 seconds. 3 long chirps
& 3 parking light flashes will confirm exit.
The unit has the ability to report the cause of the last shutdown of the
remote start system.
Enter:
1. Turn the Ignition 'switch to 'ON position.
2. Press the
3. The LED will now report the last system shutdown by flashing for one
minute in the following grouped patterns:
LED
Flashes
(-) Safety Shutdown input
1
(+) Safety Shutdown input
2
Neutral Safety Switch input
3
5
6
7
Tach. Signal has not been
8
+
button first, within 3 second, then press
SHUT DOWN DIAGNOSTICS :
button on the transmitter.
Shutdown Mode
(Hood)
(Brake) or
fail.
No RPM or
Low Voltage.
Over-rev
System timed out
Transmitter
learned
TESTING YOUR INSTALLATION:
button on the transmitter together for 6
1. Close the hood.
2. Check H7/4 White/ Black wire
connection.
1. Check H7/3 White/ Violet wire
connection.
2. Move the Enable Toggle Switch to
"ON" position. (If installed.)
3. Move the gear selector to "Park"/
"NEUTRAL" position.
4. Check H8/11 Black/White wire
connection.
Tachometer Checking Type:
Check H7/10 White/Red wire connection
Voltage Checking Type:
Program the "CHECK LEVEL" from
"Hi Check Level" to "Low Check Level"
Re-learning the RPM
(Start Feature D – 2 )
27
+
button
Hide quick links:
Advertisement
Table of Contents
