Features Programming; Alarm Feature "A" Programming - Autopage C3-RS1100 OLED Installation Manual

2 STEP DOOR UNLOCK WIRE CONNECTION FOR
GROUND SWITCHED DOOR LOCKS
H10/14 :
OEM Door Master Lock Switch
20-Pin
Pink Wire
Plug
From
Unlock
Alarm
Existing Neg.
Unlock Wire
Green Wire
Door Lock
87
H7:
Blue Wire
85
3 Pin
Door Unlock
86
Plug
To 87a
Alarm
30
+ 12V
OEM
Door Lock
Motor
X
Cut Existing Unlock
PROGRAMMING TRANSMITTER:
Note: This mode will only retain the last 4 remote transmitters programmed. If the
transmitter memory is exceeded, the security system will start deleting transmitters
from memory in chronological order.
1. Turn the Ignition 'switch ' OFF/ON' 3 TIMES and stay in ON position.
"Within 15 seconds".
2. Push the Valet switch 2 times and hold it on the 2
then release the valet switch. You are now in the Transmitter programming mode.
3. Press and hold any button of the transmitter until the siren responds with a
confirming chirp, indicating the signal has been stored into memory.
4. If you have additional transmitters (up to 4) that need to be programmed, repeat step
3 for each transmitter.
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3 parking
light flashes will confirm exit.

FEATURES PROGRAMMING:

ALARM FEATURE "A" PROGRAMMING:

1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times (holding in on the 3
long chirp is heard, then release the valet switch. You are now in the Alarm feature
"A" programming mode.
3. Press and release the transmitter button corresponding to the feature you want to
program.
a.
The siren chirps and LED pause will indicate previously setting.
b.
The factory default settings is always [1] LED flash, [1] chirp.
4 Depress the transmitter button to change the feature. Simple keep re -depressing
the transmitter button until the system advances to your desired setting.
C3 RS1100REV. A
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
POSITIVE SWITCHED DOOR LOCKS
+12V
H10/12:
20-Pin
Plug Pink Wire
From
86
Lock
Alarm
Existing Neg.
Lock Wire
Blue Wire Door Lock
H7 :
Green Wire
3 Pin Door Unlock
Plug
OEM Door
To
Lock Relay
Alarm
OEM Driver's
Door Lock
Motor
To All Other
Door Lock
Motors
PROGRAMMING
nd
push until a long chirp is heard
rd
push) until one chirp with one
18
OEM Door Master Lock Switch
87
Unlock Lock
87a 85
Existing Pos.
30
Unlock Wire
+ 12V
Existing Pos.
Lock Wire
+ 12V
87
87a
85
86
30
OEM Door
Lock Relay
X
To All Other
Door Lock
Cut Existing Unlock
Motors