Convenience Outlet/Circuit Breaker (Canadian Models Only); Oven Sensor; Bake Element; Broil Element - Maytag AER4111AA Series Service Manual

Disassembly Procedures
!
Convenience Outlet/Circuit Breaker
(Canadian Models)
1. Remove control panel, see "Control Panel" procedure
for removal.
2. Label and disconnect wire terminals from
convenience outlet and/or circuit breaker.
3. Remove screws securing outlet and/or circuit breaker
to backguard and push outward to release.
4 . Reverse procedure to reinstall convenience outlet
and/or circuit breaker.

Oven Sensor

1. Disconnect power before servicing.
2. Open oven door and remove screws securing sensor
to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3. Disconnect oven sensor at the connector terminal
and remove.
4. Reverse procedure to reinstall sensor.
NOTE: Verify connection is pushed through the
insulation.
Oven Sensor

Bake Element

1. Turn power off.
2. Remove screws securing bake element to rear of
oven wall.
3. Pull element forward to allow disconnection of
terminals on each element leg.
4. Reverse procedures to reinstall bake element.

Broil Element

1. Turn power off.
2. Remove screws securing broil element to top and
rear of oven cavity.
3. Pull broil element forward to allow disconnection of
terminals on each element leg.
4. Reverse procedures to reinstall broil element.
20
WARNING
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.

Ribbon Elements (select models)

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing element support bracket to
maintop.
3. Label and disconnect wire terminals from element
being replaced.
4. Release metal clips securing element to element
support bracket.
5. Replace and reverse procedures to reinstall element.

Coil Element Terminal (select models)

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screw securing element support bracket to
maintop.
3. Label and disconnect wire terminals from element
being replaced.

Oven Door Latch Assembly (select models)

1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing latch assembly to the front
of the oven cavity outer shell.
3. Label and disconnect wire terminals from latch
assembly.
4. Reverse procedures to reinstall door latch assembly.

Oven Door Removal

To avoid risk of personal injury or property damage,
do not lift oven door by the handle.
1. Open oven door slightly and grasp door on both
sides.
2. Lift up and off the hinge receivers.
3. Reverse procedures to reinstall oven door.
Oven Door Hinge
1. Turn off power to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure.
4. Remove side panel, see "Side Panel Removal"
procedures.
16026784
!
WARNING
© 2005 Maytag Services