Remove the PPM retainer.
5.
To replace the component, reverse the removal procedure.
Processor
CAUTION:
should attempt to replace or install the processor in this server.
IMPORTANT:
does not function properly.
IMPORTANT:
the corresponding PPM is missing.
To remove a processor:
Power down the server (on page 30).
1.
Extend the server from the rack (on page 29).
2.
Remove the access panel
3.
To avoid damage to the processor and system board, only authorized personnel
Processor socket 1 and PPM slot 1 must be populated at all times or the server
Always install a PPM when you install a processor. The system fails to boot if
("Access
panel" on page 32).
Removal and replacement procedures 47