Ppm Retainer - HP ProLiant DL380 Maintenance And Service Manual

Remove the PPM.
4.
IMPORTANT:
populated, the server halts during POST or does not boot.
To replace the component, reverse the removal procedure.

PPM retainer

To remove the component:
Power down the server (on page 30).
1.
Extend the server from the rack (on page 29).
2.
Remove the access panel
3.
Remove the PPMs ("PPM" on page 45).
4.
PPM slots must be populated when processors are installed. If PPM slots are not
("Access panel" on page 32).
Removal and replacement procedures 46