Media Drive Or Blank - HP ProLiant DL380 Maintenance And Service Manual

WARNING:
supplies. Refer all maintenance, upgrades, and servicing to qualified personnel.
CAUTION:
installed.
CAUTION:
are properly grounded (earthed) before beginning any installation procedure.
To replace the component:
WARNING:
the power cord to the power supply until the power supply is installed.
Slide the power supply into the power supply bay until the release/lock lever clicks, securing the
1.
power supply.
Connect the power cord to the power supply.
2.
Tighten the two retaining screws on either side of the power cord connector.
3.
Route the power cord:
4.
If the cable management arm has a left-hand swing, route the power cord through the cable
o
management arm.
If the cable management arm has a right-hand swing, remove the cable management arm or
o
convert it for left-hand swing. For removal instructions, see "Cable management arm with right-
hand swing (on page 31)." For conversion instructions, see the instructions that ship with the 2U
Quick Deploy Rail System.
Connect the power cord to the PDU.
5.
Be sure that the power supply LED is green
6.
Be sure that the front panel external health LED is green
7.
80).

Media drive or blank

To remove the component:
CAUTION:
unless all bays are populated with either a component or a blank.
Power down the server (on page 30).
1.
To reduce the risk of injury from electric shock hazards, do not open power
Do not run the server with one AC power supply and one DC power supply
Electrostatic discharge (ESD) can damage electronic components. Be sure that you
To reduce the risk of electric shock or damage to the equipment, do not connect
To prevent improper cooling and thermal damage, do not operate the server
("Rear panel LEDs and buttons" on page 83).
("Front panel LEDs and
Removal and replacement procedures 37
buttons" on page