Dc Power Supply - HP ProLiant DL380 Maintenance And Service Manual

Remove the hot-plug power supply.
3.
WARNING:
the power cord to the power supply until the power supply is installed.
To replace the component:
Slide the hot-plug power supply into the power supply bay.
1.
Connect the power cord to the power supply.
2.
Install the cable management arm, if removed
3.
Route the power cord through the cable management arm or power cord anchor.
4.
NOTE:
that the redundant power supply can be removed without disconnecting the power cord from
the primary power supply.
Close the cable management arm.
5.
Connect the power cord to the power source.
6.
Be sure that the power supply LED is green
7.
Be sure that the front panel external health LED is green
8.
80).

DC power supply

To remove the component:
WARNING:
before disconnecting the power cord.
Identify the failed power supply.
1.
Disconnect the power cord from the PDU.
2.
Remove the power cord from the retaining clip.
3.
Loosen the two thumbscrews on either side of the power cord.
4.
To reduce the risk of electric shock or damage to the equipment, do not connect
If using the power cord anchor, be sure to leave enough slack in the power cord so
To reduce the risk of personal injury, remove all power from the DC source
("Access the product rear
("Rear panel LEDs and buttons" on page 83).
("Front panel LEDs and
Removal and replacement procedures 35
panel" on page 31).
buttons" on page