Chapter 5 - Data Editing; Points To Keep In Mind; Prefix/Suffix Overview; To Add A Prefix Or Suffix - Honeywell Voyager 1200g User Manual

Single-line laser bar code scanner
Hide thumbs Also See for Voyager 1200g:
Table of Contents

Advertisement

5
Data Editing

Prefix/Suffix Overview

When a bar code is scanned, additional information is sent to the host computer along with the bar code data. This group of bar
code data and additional, user-defined data is called a "message string." The selections in this section are used to build the
user-defined data into the message string.
Prefix and Suffix characters are data characters that can be sent before and after scanned data. You can specify if they should
be sent with all symbologies, or only with specific symbologies. The following illustration shows the breakdown of a message
string:

Points to Keep In Mind

• It is not necessary to build a message string. The selections in this chapter are only used if you wish to alter the default
settings. Default prefix = None. Default suffix is dependent on interface.
• A prefix or suffix may be added or cleared from one symbology or all symbologies.
• You can add any prefix or suffix from the
I.D.
• You can string together several entries for several symbologies at one time.
• Enter prefixes and suffixes in the order in which you want them to appear on the output.
• When setting up for specific symbologies (as opposed to all symbologies), the specific symbology ID value counts as an
added prefix or suffix character.
• The maximum size of a prefix or suffix configuration is 32 characters, which includes header information.

To Add a Prefix or Suffix:

Step 1. Scan the Add Prefix or Add Suffix symbol
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in the
A-1) for the symbology to which you want to apply the prefix or suffix. For example, for Code 128, Code ID is "j" and
Hex ID is "6A".
Step 3. Scan the 2 hex digits from the
symbologies.
Step 4. Determine the hex value from the
wish to enter.
Step 5. Scan the 2 digit hex value from the
Step 6. Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7. To add the Code I.D., scan 5, C, 8, 0.
To add AIM I.D., scan 5, C, 8, 1.
To add a backslash (\), scan 5, C, 5, C.
Note: To add a backslash (\) as in Step 7, you must scan 5C twice – once to create the leading backslash and then to create
the backslash itself.
Step 8. Scan
Save
Repeat Steps 1-6 to add a prefix or suffix for another symbology.
Prefix
1-11
alpha numeric &
control characters
ASCII Conversion Chart (Code Page
Programming Chart
ASCII Conversion Chart (Code Page
Programming Chart
to exit and save, or scan Discard to exit without saving.
Scanned Data
Suffix
variable length
1-11
alpha numeric &
control characters
(page
5-2).
inside the back cover of this manual or scan 9, 9 for all
inside the back cover of this manual.
1252), page A-2, plus Code I.D. and AIM
Symbology Charts,
beginning on page
1252), page A-2, for the prefix or suffix you
5 - 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Voyager 1202g

Table of Contents