Do Not End Manual Activation
After Good Read Out-of-Stand
Manual Activation Laser Timeout - Button Settings
You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when the button is
held down, and after it is released. Set the length (in milliseconds) for a timeout by scanning one of the following bar codes,
then setting the timeout (from 1-65535 milliseconds) by scanning digits from the
Default = Button Hold In-Stand 5000 ms, Button Hold Out-of-Stand 5000 ms, Button Release In or Out-of-Stand 0.
Laser Timeout - Button Hold
In-Stand
Laser Timeout - Button Hold
Out-of-Stand
4 - 8
* End Manual Activation After
Good Read In-Stand
* End Manual Activation After
Good Read Out-of-Stand
Programming
Chart, then scanning Save.
Laser Timeout - Button
Release In-Stand
Laser Timeout - Button
Release Out-of-Stand