Chapter 5 - Data Editing; Prefix/Suffix Overview - Honeywell 5010 User Manual

5
Data Editing

Prefix/Suffix Overview

When a bar code is scanned, additional information is sent to the host computer
along with the bar code data. This group of bar code data and additional,
user-defined data is called a "message string." The selections in this section are
used to build the user-defined data into the message string.
Prefix and Suffix characters are data characters that can be sent before and after
scanned data. You can specify if they should be sent with all symbologies, or
only with specific symbologies. The following illustration shows the breakdown
of a message string:
Points to Keep In Mind
• It is not necessary to build a message string. The selections in this chapter
are only used if you wish to alter the default settings. Default prefix = None.
Default suffix = None .
• A prefix or suffix may be added or cleared from one symbology or all
symbologies.
• You can add any prefix or suffix from the
1252), page A-3, plus Code I.D. and AIM I.D.
• You can string together several entries for several symbologies at one time.
• Enter prefixes and suffixes in the order in which you want them to appear on
the output.
• When Setting up for specific symbologies, instead of All Symbologies, the
symbology ID value counts as an added prefix or suffix character.
Prefix
Scanned Data
1-11 variable length
alpha numeric
characters
Suffix
1-11
alpha numeric
characters
ASCII Conversion Chart (Code Page
5 - 1