Disclaimer of Product and Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete.
This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
Certain parts with limited lifetime expectancy such as LCD Panels, DVD Drives, Hard Drives are only covered for the first 10,000 hours, or 1 year (whichever comes first). Any second year warranty claims must be made to your local Datavideo office or one of its authorized Distributors before the extended warranty expires.
The MS-2800 is an all-in-one HD/SD mobile video studio with a fold away 17” HD monitor. Built around the Datavideo SE-2800 switcher, the MS-2800 provides superb 10bit 4:2:2 broadcast quality video. This mobile video studio, or portable production unit, is a ready to go solution; it will save a lot of crew time when setting up or breaking down in the field.
Installation Transport & Placement The MS-2800 is heavy – approximately 70Kg – Do not attempt to lift or move it on your own. A minimum of two people are required to lift or move this product. There are two carry handles on either side of the product, please use these handles to safely share the weight between the people lifting the unit.
Unpacking the SE-2800 Control Panel Keyboard The SE-2800 Control Panel Keyboard is held in its shipping position by a securing bolt on either side. To lower the Control Panel first remove the securing bolts as indicated below. The bolts can then be stored on each hinge bracket before lowering the Control Panel Keyboard. Setting up the TLM-170HM - 17”...
MS-2800A Front Panel TLM-170HM : 17” HD / SD monitor which slides out from a 1 RU storage position. Connections for SDI / HD-SDI, HDMI, YPbPr and Composite. Display overlays for Timecode, Center Mark, 4:3 aspect, Cinema zone and embedded audio peak meter (SDI / HDMI only).
MS-2800B Front Panel TLM-170HM : 17” HD / SD monitor which slides out from a 1 RU storage position. Connections for SDI / HD-SDI, HDMI, YPbPr and Composite. Display overlays for Time code, Center Mark, 4:3 aspect, Cinema zone and embedded audio peak meter (SDI / HDMI only).
Powering On Each product built into this Mobile Video Studio receives DC power from the PD-2A unit on the rear of the MS-2800. Please ensure the PD-2A is fed with either an AC or DC feed before attempting to switch on the MS-2800. For more information on the PD-2A please refer to its manual in the binder.
Place the MS-2800 on a strong, stable, flat surface that is capable of supporting the weight. Do not use a folding or single leg table to support the MS-2800. Specifications The MS-2800 is a combination of Datavideo products, for the specifications of a particular product please refer to its manual within the supplied binder.