De-Registering Handsets; Locating A Handset ("Paging") - Siemens Gigaset C470 IP User Manual

De-registering handsets

Please note:
If six handsets are already registered to the base station, there are two options:
– The handset with the internal number 6 is in idle status: the handset you wish to register is
assigned the number 6. The handset that was previously number 6 is de-registered.
– The handset with the internal number 6 is being used: the handset you wish to register cannot be
registered.
Registering other handsets with Gigaset C470 IP
You can register other Gigaset handsets and handsets for other devices with GAP function-
ality as follows.
¤
Begin the registration procedure on the handset in accordance with the handset's oper-
ating instructions.
¤
Press and hold (for approx. 3 seconds) the registration/paging key (page 2) on the base
station.
Please note:
You can also make changes on the base station with a Gigaset S45 or S67H handset.
De-registering handsets
You can de-register any registered handset from any registered Gigaset C47H handset.
u
Open list of internal parties.
The handset which you are using is marked with <.
q
Select the handset to be de-registered.
Press the display key.
§Options§
De-reg. H/Set No.
Select and press
~
Enter the current base station system PIN (default setting: 0000).
Press the display key to confirm the prompt.
§Yes§
a
Press and hold (idle status).
The handset is de-registered immediately, even if it is not in idle status.

Locating a handset ("paging")

You can locate your handset using the base station.
¤
Briefly press the registration/paging key on the base station (page 2).
¤
All handsets will ring at the same time ("paging"), even if ringer tones are switched off.
The current (local) IP address for the base station appears in the handset displays.
Ending paging
¤
Briefly press the registration/paging key on the base station (page 2).
Or
¤
Press the talk key c or end call key a on any handset.
.
§OK§
Using several handsets
87