Removing Oven Parts For Cleaning; Inner Door Glass; Shelf Runners; Burner Caps And Heads - Belling FSDF 60 DO Service Manual

REMOVING OVEN PARTS FOR CLEANING

Inner Door Glass

• The inner door glass panel can be
removed for cleaning but it must be
replaced the right way up. If there is any
writing on the glass, you must be able to
read it clearly when the cavity doors are
open.
• Always make sure that the glass is
pushed fully into the Stop position.
• To remove the glass panel, open the
door wide, hold the top and bottom edges
and slide out.
• Warning: DO NOT operate the appliance
without the glass panel correctly fitted.
• For your safety, glass door panels are
made of toughened glass. This ensures
that, in the unlikely event that a panel
breaks, it does so into small fragments to
minimise the risk of injury. Please take care
when handling, using or cleaning all glass
panels, as any damage to the surfaces
or edges may result in the glass breaking
without warning or apparent cause at
a later date. Should any glass panel be
damaged, we strongly recommend that it
is replaced immediately.

Shelf Runners

• Shelf runners can be removed to
enable you to clean then thoroughly.
Make sure they are cool to touch and then
grasp the runners and slide out of their
hanging holes.
CLEANING
GAS HOB

Burner caps and heads

• The slots in the burner head where the
flames burn should be cleared of deposits.
• Clean with a nylon brush, rinse and
then dry thoroughly. There may be brown
coloured markings on your burners; these
are carbon deposits or fat stains and can
be removed using a soap filled pad.
• Do not put burners in the dishwasher
or soak them. Using dishwasher powders,
washing up liquids and caustic pastes can
damage the burners.
• Burner caps and heads must be
repositioned correctly so that they sit
squarely on to the hob as shown. This is
particularly important with stainless steel
models as failure to reposition the caps
correctly may result in discolouration of
the stainless steel around the burners.