Sam4s ER-650 Operation And Program Manual page 191

CHECK # Key Program Notes
Option
DESC
KEY DISABLE
COMPULSORY FOR
ALL SALES
OPENING CLERK
HAS EXCLUSIVE
ACCESS
PRINT ON RECEIPT
PRINT ON REMOTE
ALLOW ONLY ONE
CHK PER TABLE
CHECK #
ASSIGNED BY
REGISTER
DRIVE THRU
FEATURE
ENABLED
LENGTH OF
CHECK (0-9)
SCAN CHECK #
ER-650/650R
Entry Description
Alpha You can program a descriptor. The default descriptor is
numeric CHKTRACK.
12 character
Y or N Select Y to disable this function.
Y or N Select Y you must begin a new, or recall an existing tracking
number before registering items.
Y or N
If Y, the clerk that begins a tracking number is the only clerk who
can recall a check. If N, any clerk can recall any check.
Y or N If N, the check track number and balance will not print on the
receipt.
Y or N If N, the check track number and balance will not print on the
remote.
Y or N If Y, you can begin only one check with the same table #.
Y or N
If Y, press the CHECK. # key to automatically assign the next
sequential check. Check numbers will begin with #1 and continue
until the open check report is reset, at which point the check number
will be reset and start at #1 again.
Y or N If you wish to implement a drive thru recall key, this setting
changes the function of the PBAL key to that of a recall key.
Press the PBAL key directly to automatically recall the open check
with the lowest tracking number
Y or N Set the length of check in number of digits. For example, if 4,
then checks must be used in the range from 1000, to 9999. This
setting applies only to check numbers input by the operator, not to
check numbers assigned by the register.
Y or N Choose Y to allow the check number to be input by a scanner (must
be nine digits or less).
Program Mode Programming • 179