Figure 3-1 Bar Code Scanning; Figure 3-2 Aiming Pattern; Figure 3-3 Pick List Mode With Multiple Bar Codes In Aiming Pattern - Motorola MC40 User Manual

2 Point the top of the device at a bar code.

Figure 3-1 Bar Code Scanning

Press and hold the Scan button.
3
The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is within the area formed by the
cross-hairs in the aiming pattern. The aiming dot is used for increased visibility in bright lighting conditions.
The Left and Right LEDs light red to indicate that scanning is in process, then light green, a beep sounds and the
MC40 vibrates, by default, to indicate the bar code was decoded successfully. Note that when the MC40 is in
Pick List Mode, the MC40 does not decode the bar code until the center of the crosshair touches the bar code.

Figure 3-2 Aiming Pattern

Figure 3-3 Pick List Mode with Multiple Bar Codes in Aiming Pattern

Release the scan button.
4
5 The captured data appears in the text field.
MN000111A01 - August 2013
3.4 Bar Code Capture with Imager
3-3