Download Print this page

Motorola MC40 User Manual: Bar Code Capture With Imager; Figure 33: Bar Code Scanning; Figure 34: Aiming Pattern; Figure 35: Pick List Mode With Multiple Bar Codes In Aiming Pattern

Hide thumbs

Advertisement

Bar Code Capture with Imager

To capture bar code data:
Procedure:
1 Ensure that an application is open on the device and a text field is in focus (text cursor in text field).
2 Point the top of the device at a bar code.
Figure 33: Bar Code Scanning
3 Press and hold the Scan button.
The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is within the area formed by the
cross-hairs in the aiming pattern. The aiming dot is used for increased visibility in bright lighting conditions.
The Left and Right LEDs light light green and a beep sounds to indicate the bar code was decoded successfully.
Note that when the MC40 is in Pick List Mode, the MC40 does not decode the bar code until the center of the
crosshair touches the bar code.
Figure 34: Aiming Pattern
Figure 35: Pick List Mode with Multiple Bar Codes in Aiming Pattern
4 Release the scan button.
5 The captured data appears in the text field.
MN000111A02-A | April 2014 |
Data Capture | 55
Send Feedback

Advertisement

Troubleshooting

   Also See for Motorola MC40

Comments to this Manuals

Symbols: 0
Latest comments: