Calibrations - GBC ORCA III Operation & Maintenance Manual

Installation
IN F O R M AT IO N
T he rear slitter assem blies require the use
of the m odified 1/4 in. allen w rench
e) Use the modified 1/4 allen wrench to secure two
slitter assemblies to the rear tie bar above the slitter
idler.
T ie b a r
S litte r id le r
f) Rest one on each side of the slitter idler so the
blade is resting on the pad of the standoffs.
P a d
N ever leave the slitter assem blies unsecured.
A lw ays secure in the proper rest position.
U nsecured blade can cut you!
Page 4 - 16
Orca III/ Orca III T Operation and Maintenance Manual
S litte r
a s s e m b ly
C AU T IO N

4.13 Calibrations

The following calibrations should be performed
by a qualified GBC technician before the machine is to be
operated. These calibrations may not be performed by
the operator. Improper calibrations can result in poor
lamination output.
T hese calibrations require the lam inator
to be pow ered up w hile the cabinets
are opened.
a) The main roller nip is to be calibrated.
b) The pull roller nip is to be calibrated.
c) Front and rear photo-eyes are to be calibrated.
d) The drive chains are to be checked and
tensioned if necessary.
e) Air rate on both set of rollers are to be checked.
f) Safety check and control panel operation checks
are to be performed.
© GBC Films Group February 2001
E L E C T R IC AL
S H O C K