Roll-In Cart (Trolley) Guide Rails; Electrical Connection - Alto-Shaam 6-10ML Service Maintenance Manual

C O M B I T H E R M
1.8 ASSEMBLY REQUIREMENTS

1.8.5 ROLL-IN CART (TROLLEY) GUIDE RAILS

(
ON CART EQUIPPED MODELS
Mount
REAR SUPPORT
toward the back. Fasten each end of the
with a ,
WASHER LOCK WASHER
with the slotted holes located at the
GUIDE RAIL
front of the
REAR SUPPORT
from the back of the
RAIL
, and
LOCK WASHER NUT
Do not tighten
GUIDE RAIL
end of each
GUIDE RAIL
, , and
WASHER LOCK WASHER

1.9 ELECTRICAL CONNECTION

Ensure the power supply matches the electrical
specification located on the oven data plate.
models shipped within the United States and Canada
are typically rated 110-120V, 60Hz, 1Ph and include
an electrical cord. Fuses are located behind the left
side panel.
Installation of electrical connections and wiring must
be made by a licensed electrical contractor. The oven
must be electrically grounded in accordance with local
codes, or in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70 (latest
edition). In Canada, electrical connections must
comply with the Canadian Electrical Code, CSA C22.1.
)
on the bottom of the oven
REAR SUPPORT
, and . Align each
BOLT
. Loosely fasten each
with a
REAR SUPPORT WASHER
.
fasteners. Attach the front
to the oven base with a
.
BOLT
C O M B I T H E R M G A S I N S TA L L AT I O N A N D M A I N T E N A N C E M A N UA L
G A S I N S TA L L AT I O N
®
Push the roll-in cart (trolley) into the oven, center
the cart right-to-left, and close the oven door. From
the rear of the oven, slide both guide rails toward
the center of the oven until they make contact with
the roll-in cart. Lock the
GUIDE
tightening both
,
. At the front of the oven, make certain
SUPPORT
contact has been made between the oven and the
cart along the total width of the oven to create a
complete seal. When a full seal has been determined,
recheck each connection to make certain it has been
fully tightened.
ACCESSING CONTROL AREA
Access the electrical control system through the left
Gas
side panel of the oven.
MAKE CERTAIN TO DISCONNECT POWER AND
ENSURE THE GAS SUPPLY IS SHUT OFF
An electrical diagram is affixed inside the left-hand
side control area. A copy of the electrical diagram is
also located at the back of this manual. Service or
changes must be done by a licensed electrical
contractor and in accordance with local codes
and regulations.
GUIDE RAILS
at the back of the
NUTS
BEFORE REMOVING THE LEFT SIDE PANEL.
— 6 4 7 0
M L
into position by
REAR
. 5
P G