JRC JLR-20 Instruction Manual page 73

The following submenus are available.
• SENSOR THROUGH: Outputs through data from the sensor. Connects to equipment requiring
• DATA OUT1:
• DATA OUT3:
• DATA OUT4/IN4:
• DATA OUT5:
• LOG PULSE:
Memo
• In Maintenance Mode settings can be changed press and hold both
seconds or more to go to the mode.
• HDT and THS sentences cannot both be set at the same time for sensor throughput.
• Cannot be set for some bit rates (high rates) and output intervals (short intervals).
If this is the case, decrease the bit rate, increase the output interval, and decrease the
output sentences.
• Refer to "2.3 Cable Connection" for details regarding connecting external devices.
high speed output (radar, etc.). (Select from NMEA, NSK, or AD-10)
Select from NMEA, NSK, or AD-10.
Select NMEA or NSK.
Select from NMEA, NSK, or BEACON.
Current data can be entered for CURRENT. (CUR and VBW sentences)
Select NMEA or NSK.
Select from OFF, 200p/nm, or 400p/nm.
and for 3
5-23