SMART Board 600ix Configuration And User's Manual page 5

I M P O R T A N T I N F O R M A T I O N
You must connect the USB cable that came with your SMART Board interactive whiteboard
l
to a computer that has a USB compliant interface and that bears the USB logo. In addition,
the USB source computer must be compliant with CSA/UL/EN 60950 and bear the CE mark
and CSA and/or UL Mark(s) for CSA/UL 60950. This is for operating safety and to avoid
damage to the SMART Board interactive whiteboard.
I
I M P O R T A N T
Use the SMART Board 685ix and D685ix interactive whiteboard systems installation
l
instructions (smarttech.com/kb/137394) to install your interactive whiteboard, projector and
ECP.
Make sure an electrical socket is near your SMART product and remains easily accessible
l
during use.
Using your SMART product near a TV or radio could cause interference to the images or
l
sound. If this happens, move the TV or radio away from the projector.
Operation
W
W A R N I N G
If you are using an audio system, use only the power supply included with that product.
l
Using the wrong power supply might create a safety hazard or damage the equipment. If in
doubt, refer to the specification sheet for your product to verify the power supply type.
Do not climb (or allow children to climb) on a wall- or stand-mounted SMART Board
l
interactive whiteboard.
Do not climb on, hang from or suspend objects from the projector boom.
Climbing on the interactive whiteboard or projector boom could result in personal
injury or product damage.
C
C A U T I O N
Do not block the projector's ventilation slots and openings.
l
Avoid putting the projector into Standby mode during the lamp ignition phase because this
l
can lead to premature lamp failure. Keep the projector lamp on for a minimum of 45 minutes
before putting it into Standby mode to preserve the lamp life.
iii