SMART Board 600ix Configuration And User's Manual page 29

C H A P T E R 3
Using your interactive whiteboard system
Setting Use
Network menu
Network and VGA Activates the projector's VGA Out and
Out RJ45 connector and network features.
Status Displays the current network status
(Connected, Disconnected or Off).
DHCP Displays the status of the network's
Dynamic Host Configuration Protocol
(DHCP) as On or Off.
Password E-mails the network password to the
Reminder predefined e-mail recipient.
IP Address Displays the projector's current IP
address in values between 0.0.0.0 and
255.255.255.255.
Subnet Mask Displays the projector's subnet mask
number in values between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector's default
network gateway in values between
0.0.0.0 and 255.255.255.255.
DNS Displays the projector's primary
domain name number in values
between 0.0.0.0 and 255.255.255.255.
MAC Address Displays the projector's MAC address
in xx-xx-xx-xx-xx-xx format.
Group Name Displays the projector's workgroup
name as set by an administrator
(maximum 12 characters).
19
Notes
The default is off.
The default is on.
On enables a DHCP server on the
network to automatically assign an IP
address to the projector.
Off enables an administrator to assign
an IP address manually.
See Web page management on page
53 to set up a destination e-mail
address.
To change the projector's IP address,
use the RS-232 connector (see
Network controls on page 70) or use a
DHCP server to assign a dynamic IP
address, and then set a static IP
address using the network remote
management feature (see Remotely
managing your system through a
network interface on page 53).
You can set the projector's workgroup
name using the remote management
features (see Remotely managing your
system through a network interface on
page 53 and Remotely managing your
system through an RS-232 serial
interface on page 61).