SMART Board 600ix Configuration And User's Manual page 44

C H A P T E R 5
Maintaining your interactive whiteboard system
When replacing the projector lamp:
l
Put the projector into Standby mode and wait 30 minutes for the lamp to cool
o
completely.
Do not remove any screws other than those specified in the lamp replacement
o
instructions.
Wear protective eyewear while changing the lamp. Failure to do so can cause injuries
o
including loss of eyesight if the lamp shatters or bursts.
Use only replacement lamps approved by SMART Technologies. Contact your
o
authorized SMART reseller for replacement parts.
Never replace the lamp assembly with a previously used lamp assembly.
o
Always handle the fragile lamp assembly with care to prevent premature lamp failure or
o
exposure to mercury. Use gloves when touching the lamp. Do not touch the lamp with
your fingers.
Recycle or dispose of the lamp as hazardous waste in accordance with local
o
regulations.
You need a Phillips No. 2 screwdriver and a flat screwdriver to complete these procedures.
g
To remove the old lamp
1. Press the Power
Standby mode.
2. Wait at least 30 minutes for the projector to cool down.
3. Disconnect the power cable from the wall outlet.
34
button twice on the remote control or the ECP to put the projector into