SMART Board 600ix Configuration And User's Manual page 85

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
These commands control the current system settings. These commands are available when the
projector is in Standby mode and when it is on.
Command
set restoredefaults
set lamphrs [target]
set vgaoutnetenable [target] =on
set usb1source [target]
set usb2source [target]
T
T I P
The set usb1source and set usb2source commands are only applicable to SMART UX60
projectors running DLP firmware version 1.0.0.4 or later.
N
N O T E
The Network and VGA Out setting's features are off by default. Select on to activate these
features.
75
Command target range
[none]
=0
=off
=vga1
=vga2
=hdmi
=disabled
=vga1
=vga2
=hdmi
=disabled
Response
restoredefaults=done
lamphrs=0
vgaoutnetenable=[target]
usb1source=[target]
usb1source=[target]