Panasonic MINAS-BL GP series Instructions Manual page 11

How to use Digital key pad (option)
Description of various modes
Displays rotation speed (actual speed), commanded speed, internal DC
voltage, load factor, torque, and present position on 5-digit LED. This mode is
set when power is turned on.
Monitor mode
Control changes to this mode when
number mode, parameter setting mode, point number mode, and point setting
mode.
Displays a parameter number (
Parameter Control changes to this mode when
number mode number mode.
Parameter number can be changed and selected by
Displays the detail of parameter (setting) in flashing.
Control changes to this mode when
Parameter
setting mode Change setting by and
When switch is pressed after change of setting, it is saved in EEPROM.
Displays a parameter number (
Control shifts to this mode when
Point number
mode monitor mode.
Point number can be changed and selected by
Displays the present position of motor (distance from home) in flashing.
(If homing is not completed,
• When present position is greater than 99999,
• When present position is smaller than -99999,
Ex. 1) When present position is 123456, only lower 4 digits
displayed.
Ex. 2) When present position is -20,
Teaching
Control shifts to this mode when
mode
mode.
When or switch is pressed after completion of homing, the motor can
be operated.
If homing is not completed yet, homing operation is started when
is pressed for 4 seconds.
When switch is pressed, the present position is set in parameter as a
point setting, and saved in EEPROM
<Information>
Present position is the distance from the home, indicated in pulses (288 pulses/rotation).
switch is pressed in parameter
to ) in flashing.
switch is pressed in parameter
and switch.
switch is pressed in monitor mode.
switch.
to ) in flashing.
switch is pressed for 4 seconds in
and switch.
is displayed.
is displayed.
is displayed.
is displayed.
switch is pressed in point number
－ 20 －
Operation of the Digital key pad
Basic operations
Trip
reset
are
Trip detail display mode
switch
• Trip can be reset by pressing
switch at the same time.
Display shifts to monitor screen after resetting.
• Shifts to parameter number made when
switch is pressed.
Displays monitored details set by Pr7A
Power-on
(see P.45).
Monitor mode
• Changes display on 5-digit
LED with
DATA
MODE
SET
Parameter number mode
Displays the contents of
displayed parameter (setting).
Displays parameter number.
• Number is changed by
and switch.
• Exit this mode with
switch (returns to
monitor).
DATA
DATA
MODE
SET
SET
Parameter setting mode
When trip
occurs, trip
display mode is
set by
switch.
and • Value is changed by
(Such value is effective on the spot.)
• Value is written in EEPROM by
• Exit this mode with
writing in EEPROM.
－ 21 －
switch.
MODE
DATA
SET
and switch.
switch.
switch without