If You Have A Problem; Lubrication - Hoover U5063-930 Owner's Manual

If you have a problem

This appliance was inspected thoroughly and was in good operating
condition when it was shipped from the factory. If a minor problem occurs,
it usually can be solved quite easily when the cause is found. Therefore,
this check list.is provided for your convenience.
Problem
1. Not firmly plugged in.
Cleaner
2. No voltage in wall plug.
won't
3. Blown fuse/tripped
run
1. Broken or worn belt.
Cleaner
2. Agitator brush roll
won't
pick up
3. Bag full.
4. Incorrect carpet height
1. Hose clogged.
Cleaning
tools won't
2. Hose connector inserted
pick up
1. Incorrect carpet height
Cleaner
hard
to push

Lubrication

The motor is equipped with bearings which contain sufficient lubrication for
the life of the motor. The addition of lubricant could cause damage. Do not
add lubricant to motor bearings.
The agitator is equipped with two ball bearings that should be lubricated
periodically by a Hoover Factory Service Center or an Authorized Hoover
Warranty Service Dealer (Depot).
Possible cause
breaker.
worn.
setting.
incorrectly.
setting.
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
breaker.
1. Replace belt.
2. Replace brush roll.
3. Change paper bag.
4. Move nozzle control
knob to type of carpet
being cleaned.
1. Remove hose and tools;
remove obstruction.
2. Re-insert hose connector
properly (page 16).
1. Move nozzle control
knob to a higher setting.
24