If You Have A Problem - Hoover SteamVac FH50010 Operating, And Servicing Instructions

Hide thumbs Also See for SteamVac FH50010:
Table of Contents

Advertisement

Available languages

Available languages

To Replace Belt or Brushroll
3.5
3.6
Remove belt. Dispose
Place belt on motor
of old belt.
shaft, then slip brush-
roll through belt. Place
belt in area of brush-
roll without bristles.

4. If you have a problem

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
check list below.
WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING.
PROBLEM
POSSIBLE CAUSE
Cleaner won't run Power cord not firmly
plugged into outlet.
Blown fuse or tripped
breaker.
Needs service.
Cleaner won't
Dirty Water Tank Door not
pick-up or low
installed.
suction
Dirty Water Tank is not
installed correctly.
Dirty Water Tank is full.
Dirty water passage clogged.
Foam filter is dirty.
Water escaping
Dirty Water Tank is full.
from Cleaner
Dirty Water tank is not
installed correctly.
Solution reservoir not
installed properly.
Cleaner won't
Solution reservoir not
dispense solution
installed properly.
Needs service.
Motor noise
The float in the Dirty Water
becomes
Tank has been activated.
high-pitched
3.7
3.8
With belt in place,
Replace belt cover by
pull and slide brush
inserting end furthest
roll into nozzle, mak-
from brushroll first.
ing sure that the
Then place front of
brushroll end caps
belt cover into posi-
are in the correct
tion. Secure by replac-
orientation (Diagram
ing the two screws.
7a). IMPORTANT:
ROTATE BRUSHROLL
MANUALLY TO
MAKE SURE BELT IS
NOT TWISTED OR
PINCHED.
POSSIBLE SOLUTION
Plug unit in firmly.
Check fuse or breaker in home. Replace
fuse/reset breaker.
Take to service center. To find nearest
location, visit our website at www.hoover.
com or call 1-800-263-6376.
Insert Dirty Water Tank Door - Pg. 7, 8.
Review Placing Dirty Water Tank in base of
cleaner - Pg. 8.
Empty Dirty Water Tank - Pg. 7.
Clean Dirty Water Tank - Pg. 7.
Clean filter. Review Emptying & Cleaning the
Dirty Water Tank - Pg. 7.
Emptying Dirty Water Tank - Pg. 7.
Review Placing Dirty Water Tank in base of
cleaner - Pg. 8.
Review Review Solution Reservoir Installa-
tion - Pg. 6.
Review Review Solution Reservoir Installa-
tion - Pg. 6.
Take to service center. To find nearest loca-
tion, visit our website at www.hoover.com
or call 1-800-263-6376.
Review Emptying & Cleaning the Dirty Water
Tank - Pg. 7.
10

Advertisement

Table of Contents
loading

Table of Contents