Page 1
Owner’s Manual English pp. 1-14 Spanish pág. 15-22 Upright Va c u u m French p. 23-30 C l e a n e r Review this manual before operating cleaner.
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).
The assembled cleaner will look like this drawing. If you need assistance with any step of the assembly, Visit us on-line at www.hoover.com to find the service outlet nearest you (click on the “Service” button) or Call 1-800-944-9200 for an automated referral of authorized service out- let locations (U.S.
“UP” Handle assembly Attach cord N o t e : The small red tab (E) above the ON/OFF switch (F) is for Place upper (B) and lower (C) handle sections on a flat surface shipping purposes only and may fall off during assembly. If it with cord hooks (A) on top.
1-10 1-11 1-12 Attach handle Push bolt into hole on lower f ront of handle. Place n u t in recessed area at back of h a n d l e. Hold nut in place while tightening With cord hooks to the back, place If bolt will not go through hole easily, bolt securely with a scre w d r i v e r.
Page 6
1-20 1-21 1-19 Attach filter bag Push bag collar firmly onto dirt tube. To replace bag door, insert the tabs (V) Tuck top and bottom of bag into bag on bottom of bag door into the slots on Align opening (U) in filter bag with dirt compartment.
CAUTION: When cleaner is turned on, 1-29 1-28 the agitator brush roll will continue to rotate while cleaner handle is in upright position. Avoid tipping clean- er or setting it on furniture, fringed area rugs or carpeted stairs during tool use. Slide crevice tool (Z) onto projection.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.
2-10 2-11 Edge cleaning Cleaning lightweight Stair cleaning Edge cleaning is provided on both sides rugs A stair cleaning handle has been of nozzle to remove dirt in carpet near designed for ease in using your cleaner To clean lightweight flexible rugs, stand baseboards and furniture.
Filter bags may be purchased from your local Authorized Hoover Dealer (Depot), The following sections are concerned Leading Retailers, from Hoover Factor y with proper maintenance of the cleaner. Service Centers, using the order form Familiarize yourself with these home packed with your cleaner, or through maintenance tasks and keep this owner’s...
Discard used bag. The headlight (some models only) What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover P a r t No. 27313-101. Remove bulb by pulling straight out of socket; push new bulb into socket until it locks in place.
3-10 Positioning belt and agitator Removing hood Replacing bottom plate Slip agitator through new belt (with let- Remove hood by turning cleaner over Place the three tabs on bottom plate into tering toward outside of cleaner) and and removing nozzle control knob on slots in front of cleaner body.
The agitator is equipped with two ball Problem: Cleaner won’t run Problem: Cleaning tools won’t bearings that should be lubricated peri- pick up odically by a Hoover Factory Service Possible cause Center or an Authorized Hoover Possible cause Possible solution Warranty Service Dealer (Depot).
(Domestic Use) genuine HOOVER parts, locate the neare s t Hoover Factory Service Center or Your HOOVER® appliance is warr a n t e d Authorized Hoover Warranty Service in normal household use, in accord a n c e D e a l e r ( D e p o t ) b y : with the Owner’s Manual against original...