Iconnect; Ethernet Communications - Intermec CK60 User Manual

iConnect

Ethernet Communications

CK60 Mobile Computer with Windows Mobile User's Manual
The default network adapter or radio is dependent on what radios are
installed in your CK60. With the iConnect menu, using the Enable
feature, you can specify "802.11b," "Ethernet," or "No Networking" to
load onto your CK60 when a cold-boot is performed.
If you had specified a network prior to when a warm-boot is performed on
the CK60, the iConnect application restores your network interfaces to
what they were before the warm-boot was performed.
See the Developer's Support area of the Intermec web site for the latest
information on network adapters for your unit.
To access the iConnect menu, tap the iConnect icon (shown to the left)
above your command bar for the following menu:
• Select Dismiss from the iConnect menu to end the session without
exiting the application.
• Select Exit iConnect to exit the application. To access the iConnect
application after you have exited it, perform a warm-boot on the CK60.
The iConnect icon then reappears above the command bar.
If your system does not contain an 802.11a/b/g radio, then Ethernet
networking using DHCP is selected as the default.
To view information about the Ethernet communications
• Select Tools > Ethernet IP Settings from the iConnect menu for the
following:
Chapter 5 — Network Support
139