Intermec CK60 User Manual page 163

CK60 Mobile Computer with Windows Mobile User's Manual
To disable 802.1x security and enable WEP encryption
• Set 8021x Security as "None," Association to "Open," and Encryption
to "None."
To enable WEP encryption
1 Set 8021x Security as "None" and Association to "Open" or "Shared"
as required to match the settings in your access point.
Note: "Open" is the recommended choice as the "Shared" key
authentication has security weaknesses.
2 Set Encryption to "WEP."
3 Select a data transmission key from the Data TX Key drop-down list
near the bottom of this screen.
4 Enter an ASCII key or a hex key either 5 or 13 bytes long based on the
radio capability in the appropriate Key # field. Set a 5-byte value for 64-
bit WEP or a 13-byte value for 128-bit WEP. Precede hex keys with 0x
and make sure the keys use 5 or 13 hex pairs.
Chapter 5 — Network Support
149