Intermec CK60 User Manual page 160

Chapter 5 — Network Support
146
d Enter a User Name and Subject Name. You can also enter a Server 1
Common name or Server 2 Common name to increase security.
If you select "TLS:"
a Load a user and root certificate on your CK60 (see
b For Validate Server Certificate, select "Yes," then press Enter.
Note: You must have the date on the CK60 set correctly when you
enable Validate Server Certificate.
c You must enter a User Name and Subject Name. You can also enter a
Server 1 Common name or Server 2 Common name if you want to
increase your level of security.
If you select "LEAP" or "EAP-FAST:"
a Select User Name, then type your user name.
b Press Enter.
c Select User Password, then type a user password.
d Press Enter.
6 Select File > Save Settings, then select File > Exit to close the Intermec
Settings applet.
Using Static WEP Security
The CK60 uses the Wired Equivalent Privacy (WEP) protocol to add
security to your wireless network based on the 802.11b/g standard. To use
WEP security, you need an access point with an 802.11b/g radio.
To configure static WEP Security with Funk Security
Use this procedure to set Static WEP security with Funk security.
1 Make sure you have configured the communications and radio
parameters on your CK60 and that Funk is your security choice.
2 Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with "X" being "1" through "4.".
3 For Association, select "Open" and press Enter.
CK60 Mobile Computer with Windows Mobile User's Manual
page 160).