Intermec CK60 User Manual page 164

Chapter 5 — Network Support
150
To enable WPA encryption using a pre-shared key
1 Set 8021x Security as "None."
2 Set Association to "WPA."
3 Enter the passphrase as ASCII (12345) in the Pre-Shared Key field.
To enable WPA2 encryption using a preshared key
1 Set 8021x Security as "None."
2 Set Association to "WPA2."
3 Set Encryption to either "TKIP" or "AES."
4 Enter the passphrase as ASCII (12345) in the Pre-Shared Key field.
PEAP (Protected EAP)
This protocol performs secure authentication against Windows domains
and directory services. It is comparable to EAP-TTLS (see
in its method of operation and its security, though not as flexible. This does
not support the range of inside-the-tunnel authentication methods
supported by EAP-TTLS. Microsoft and Cisco both support this protocol.
Use "PEAP" to configure the use of PEAP as an authentication protocol
and to select "Open," "WPA," "WPA2," or "Network EAP" as an
association mode.
CK60 Mobile Computer with Windows Mobile User's Manual
page 153), both