Intermec CK60 User Manual page 159

CK60 Mobile Computer with Windows Mobile User's Manual
6 Select File > Save Settings, then select File > Exit to close the Intermec
Settings applet.
Using 802.1x Authentication
802.1x authentication provides centralized user authentication using an
authentication server, authenticators (access points), and supplicants. These
components communicate using an EAP authentication type, such as TLS
(Transport Layer Security) or PEAP (Protected Extensible Authentication
Protocol). 802.1x security provides data encryption using dynamic WEP
key management. To use 802.1x security, you need:
• An access point with an 802.11b/g radio.
• A CK60 with an 802.11b/g radio and the 802.1x/WPA security option.
To configure 802.1x Security with Funk Security
Use this to set 802.1x security on the CK60 with Funk security.
1 Make sure you have configured the communications and radio
parameters on your CK60 and that Funk is your security choice.
2 Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with "X" being "1" through "4."
3 For Association, select "Open" and press Enter. When working with
Cisco Aironet access points, you can select "Network-EAP."
4 For Encryption, select "WEP" and press Enter.
5 For 8021x, select "PEAP," "TLS," "TTLS," "LEAP," or "EAP-FAST"
and press Enter.
If you select "TTLS" or "PEAP:"
a Select User Name, type your user name, then press Enter.
b Select User Password, type a user password, then press Enter.
c For Validate Server Certificate, select "Yes," then press Enter.
Note: You must have the date on the CK60 set correctly when you
enable Validate Server Certificate.
Chapter 5 — Network Support
145