ELECRAFT KX3 Assembly Manual page 29

Check the spacing between transformer T7 and the standoff shown below. If they are touching, carefully
push T7 away. There might not be as much space between them as shown. All that is required is that they are
not in actual contact.
Thread 2-56 screws into the remaining four holes in the RF board as shown in Figure 40, make adjustments
as necessary for them to fit just as you did in the previous step and then remove them. These screws will be
replaced later to secure the battery holders.
Figure 39. Checking T7 Clearance.
Figure 40. Checking the Alignment of the Battery Holder Standoffs.
27