ELECRAFT KX3 Assembly Manual page 26

Ultra-portable 160-6 meter, all-mode transceiver

Hide thumbs Also See for KX3:

Table of Contents

Install the four #2 (smaller) standoffs in the bottom cover as shown in Figure 33. Place the lock washers

between the standoffs and the cover as shown to provide proper clearance for the RF board when it is

installed. Leaving the washers out may result in damaged components on the RF board.

Locate the antenna connector assembly with the low-pass filter (LPF) attached and carefully slide the

spacer over the cable and toroid and up onto the threaded portion of the connector (see Figure 34).

Figure 33. Installing 2-56 (Smaller) Standoffs in the Bottom Cover.

Figure 34. Putting the Spacer on the Antenna Connector.

Table of Contents