ELECRAFT KX3 Assembly Manual page 19

Install the side panels as shown in Figure 19. The MIC connector is supplied with the finish nut threaded
onto it. Remove the nut and replace it as shown after mounting the side panel.
Mount the large knob on the VFO encoder shaft as shown in Figure 20. Best practice is to align the set
screw with the flat on the shaft. Adjust the height of the knob for the desired amount of friction against the felt
washer. A good starting point is to let the weight of the knob determine the pressure. The rubber finger grip
slides off to allow adjustment later.
Some set-screws turn stiffly in the knob, making it difficult to tell when it has reached
the encoder shaft. Try yours before placing the knob on the shaft to see how much torque is
required. Also, exercising it this way may loosen the fit slightly.
Figure 19. Mounting the Side Panels.
Figure 20. Mounting the VFO Knob.
17