Through-Hull Fittings; Quick Oil Drain System - CORRECT CRAFT Super Air 210 2011 Owner's Manual

Through-Hull Fittings

All fittings that actually pass through the hull on the wetted surface
are caulked in. These are not serviceable and must not be tampered
with.

Quick Oil Drain System

Change the engine oil after the first 25 hours of operation, then
after every 50 hours. The boat must be removed from the water to
use the quick oil drain system. There is a drain hose attached to the
bottom of the oil pan with a small plug screwed into the loose end
of the hose. Remove the drain plug (T-handle) (A), located in the
bilge area, and put the end of the drain hose through the drain
hole.
Make sure there are no kinks or sharp bends in the hose. Remove
the plug at the end of the hose and drain the oil into a container
under the boat. The engine will drain most efficiently when the oil
is warm. Allow several minutes for the oil to settle and drain.
Dispose of used oil in an environmentally safe manner.
Be sure the engine is off when you are draining your oil.
!
engine oil can cause death or serious injury. Wash
affected area immediately with soap and water.
Care and Maintenance
NOTICE
Prolonged or repeated contact of used
8-7