Erasing the User Codes
Make sure the system indicator light is OFF.
Enter the Master Embedded Code, press and release the 1/2 key
and the 7/8 key at the same time to erase the system user codes.
The keyless ignition will now act as if there are no codes in memory.
Pressing the START key will unlock the system and pressing the
STOP key will lock it without entering a code. Follow the steps in
"Programming The Primary User Code" in this section.
Nautique Digital Cruise
Home Screen
When the ignition is turned to the ON position, the Nautique
Digital Cruise gauge will flash the Nautique corporate logo until the
internal software is booted up, then the display screen will show the
following:
• Set Speed – displays the last speed that was selected as the
desired controlled speed
• ON/OFF – defines if the speed control function is activated
or not
• Depth – displays current water depth from the keel
• Water – displays current lake water temperature
• Actual Speed – displays the actual speed the boat is traveling
Controls and Indicators
4-21