Direct Dialling - Memory Numbers - Alpha Technologies IP Bell – 01 User And Installation Manual

5. After the dialling is finished, it waits for this set time period. After the time
period elapsed and there is no call established or there is a busy tone
detected, then the IP Bell doorphone hangs up [range 04-99]. The dialling is
repeated is case it is set to mode of dialling 2 groups of numbers.
6. By default the status of the doorphone is signalled acoustically. However
this might cause some issues or the customer may not like this signalling.
The signalling can be turned off, then all other tones are enabled
tones of picking up and hanging up the line)
7. By default the status of the doorphone is signalled acoustically. However
this might cause some issues or the customer may not like this signalling.
The signalling can be turned off, then only tones of picking up and hanging
up the line are enabled
8. default values – makes settings of the default values. After making changes,
please click on button „save changes".
3.2.5 Direct dialling – memory numbers
To enable changes, please do not forget to click on button „save changes".
1. number of the pushbutton (memory) – the telephone number of up to 25
digits, which we wish to save. The numbers saved in this column are
numbers of the first group, or these numbers belong to Day mode. In case
you use the P2P mode, then you save into the memory the IP address in
the format 192*168*1*231, where „*" means „.". If you use the SIP server
mode, then you save telephone numbers into the memory of the IP Bell´s
pushbuttons, for example 117.
42
(all other signalling tones are disabled)
IP Bell
- User guide and installation manual
(except for