Parameter Settings Of The Ip Bell Doorphone; Basic Parameters - Alpha Technologies IP Bell – 01 User And Installation Manual

3.2 Parameter settings of the IP Bell doorphone

3.2.1 Basic parameters

To enable changes, please do not forget to click on button „save changes".
1. mode of choosing numbers – the numbers are either chosen according to
Day / Night mode or they are selected from the first or second group – see
more in chapter 2.2 on page 20.
2. Character star * or hash # for call prolongation (10sec. before the end of the
call the doorphone sends an alert, then you can extend the call).
3. Command for hanging up the doorphone from the telephone [1 or 2 digits].
It is useful to set the same command both for switching on the contact and
hanging up the doorphone, see chapter 3.2.3. A command with one
character is entered by replacing the first character by star * character. For
example a two digit code 55 can be shortened to a one digit code by
entering *5. The command is then intiated by one pressing the 5 key on the
telephone.
4. Codes for switching DAY / NIGHT mode [1 or 2 digits].
Remark switching to Day/Night mode stays set in the doorphone even after
unplugging it from a power supply
One digit command is entered by replacing the first digit by the star
character *. E.g. a 2-digit code 11 is shortened to a one digit code by
entering *1. The command is then initiated by pressing the key 1 on the
telephone.
.
IP Bell
- User guide and installation manual
37