Program the Lift Call Line elevator intercom using an SMS message via the Alphatech 4G GSM gateway.
First you need to save your mobile number on the SIM card of the 4G BlueGate Brave GSM gateway. Only
SMS messages sent from numbers stored on the SIM card are accepted.
Procedure for putting the 4G GSM gateway into operation:
1. Prepare a SIM card suitable for a 4G GSM gateway.
2. Disable the PIN code on this SIM card, e.g. using your mobile phone.
3. Put the 4G GSM gateway into operation: Insert the SIM card into the 4G GSM gateway, connect the
antenna and connect the power adapter. Wait approx. 2 minutes until the 4G GSM gateway logs into
the GSM network. Check the yellow LED next to the antenna icon to find out the signal strength (1 to 5
flashes indicate the signal strength, 1 the weakest and 5 the strongest signal).
4. From your mobile phone, now send an SMS message in the format INIT 0000 to the SIM card of the
4G GSM gateway. This command serves to save your mobile number as an administrator.
5. The 4G GSM gateway will reply to you with an SMS message WRITE xxxxx (your mobile number).
This confirms that you are an administrator authorized to send commands to the 4G GSM gateway.
6. Now the 4G GSM gateway is ready to receive SMS messages/commands which, after receiving, the
gateway forwards using DTMF to the Lift Call Line (LCL) of the lift intercom.
LIFT INTERCOM SYSTEM
LiftCall-Line with BlueGate 4G
Need help?
Do you have a question about the 4G-Lift-Call-Line and is the answer not in the manual?
Questions and answers