Comtech EF Data KST-2000B Installation And Operation Manual page 170

Ku-Band Satellite Transceiver
FSK Remote Control Commands
Parameter Command
Type (Instruction
Code and
qualifier)
Configuration LOC=
Lock
Concise Up n.a.
Converter Status
Concise Down n.a.
Converter Status
Concise HPA n.a.
Status
Arguments for Description of arguments
Command or (note that all arguments are ASCII numeric codes, that is, ASCII
Response to codes between 48 and 57)
Query
1 byte Command or Query
<add/LOC=x'cr'
>add/LOC='cr''lf'
<add/LOC?'cr'
>add/LOC=x'cr''lf'
Where: X = 0 (Unlock)
1 (Lock)
4 bytes Query only.
<add/CUS?'cr'
>add/CUS=ABCD'cr''lf'
Where: A=Overtemperature Status, 0=OK, 1=FLT
B=L-Band Synthesizer Lock Status, 0=OK, 1=FLT
C=Ku-Band Synthesizer Lock Status, 0=OK, 1=FLT
D=Interprocessor Comm. Status, 0=OK, 1=FLT
4 bytes Query only.
<add/CDS?'cr'
>add/CDS=ABCD'cr''lf'
Where: A=Overtemperature Status, 0=OK, 1=FLT
B=L-Band Synthesizer Lock Status, 0=OK, 1=FLT
C=Ku-Band Synthesizer Lock Status, 0=OK, 1=FLT
D=Interprocessor Comm. Status, 0=OK, 1=FLT
5 bytes Query only.
<add/CHS?'cr'
>add/CHS=ABCDE'cr''lf'
Where: A=Overtemperature Status, 0=OK, 1=FLT, 2=NA
B=9.75V Status, 0=OK, 1=FLT, 2=NA
C=-5V Status, 0=OK, 1=FLT, 2=NA
D=BIAS Voltage Summary Status, 0=OK, 1=FLT, 2=NA
E=Interprocessor Comm. Status, 0=OK, 1=FLT, 2=NA
Note: Item D is the logical OR (shown as 1 or 0) of all the bias voltage
status information as shown:
E-18
Revision 9
MN/KST2000AB.IOM
Response to Command (target to
controller)
LOK= (message ok)
LOK? (received ok, but invalid
arguments found)
LOK* (message ok, but not permitted in
current mode)
CUS= (message ok)
CUS? (received ok, but invalid
arguments found)
CUS* (message ok, but not permitted in
current mode)
CDS= (message ok)
CDS? (received ok, but invalid
arguments found)
CDS* (message ok, but not permitted in
current mode)
CHS= (message ok)
CHS? (received ok, but invalid
arguments found)
CHS* (message ok, but not permitted in
current mode)
Query
(Instruction
Code and
qualifier)
LOC?
CUS?
CDS?
CHS?