Comtech EF Data KST-2000B Installation And Operation Manual page 117

Ku-Band Satellite Transceiver
Terminal Mode Commands
External Command
Fault Enable Response
Status
Response
HPA Command
Power Enable Response
Status
Response
LNA or LNB Command
Power Enable Response
Status
Response
Transmit IF Command
Output Power- Response
up Condition
Status
Response
HPA Command
Fault Polarity* Response
Status
Response
<add/XFE_xxx'cr'
>add/XFE_xxx'cr''lf']
<add/XFE_'cr'
>add/XFE_xxx'cr''lf']
<add/HPE_xxx'cr'
>add/HPE_xxx'cr''lf']
<add/HPE_'cr'
>add/HPE_xxx'cr''lf']
<add/LPE_xxx'cr'
>add/LPE_xxx'cr''lf']
<add/LPE_'cr'
>add/LPE_xxx'cr''lf']
<add/TXPU_xxxx'cr'
>add/TXPU_xxxx'cr''lf']
<add/TXPU_'cr'
>add/TXPU_xxxx'cr''lf']
<add/HFP_xx'cr'
>add/HFP_xx'cr''lf']
<add/HFP_'cr'
>add/HFP_xx'cr''lf']
B–7
Where: xxx= ON/OFF
Default is ON
Note: States whether or not the system should take action
upon any, or report any, HPA, TWTA, SSPA fault
notification.
Where: xxx = ON/OFF
Default is OFF
Note: For Comtech EF Data SSPA only, which turns
ON/Off DC voltage supplied to HPA.
Where: xxx = ON/OFF
Default is OFF
Where: xxxx = Last or OFF where Last = last known
state, OFF = OFF
This command selects the state that the TX-IF Output
will be at power-up.
Where: xx = HI or LO
This command informs the M&C which polarity is to be
considered a fault when reading the HPA fault line.
* Command/response is valid only when used with an
Avantek 25W HPA.
Revision 9
MN/KST2000AB.IOM