Comtech EF Data KST-2000B Installation And Operation Manual page 160

Ku-Band Satellite Transceiver
FSK Remote Control Commands
Parameter Command
Type (Instruction
Code and
qualifier)
Reference REF=
Frequency Adjust
Set Physical SPA=
Address
LNA Calibrated CAL=
LNA Power LCS=
Enable
LNA Fault LFL=
Enable
Arguments for Description of arguments
Command or (note that all arguments are ASCII numeric codes, that is, ASCII
Response to codes between 48 and 57)
Query
3 bytes Command or Query.
<add/REF=nnn'cr'
>add/REF='cr''lf'
<add/REF?'cr'
>add/REF=nnn'cr''lf'
Where: nnn = 000 to 255
3 bytes Command or Query.
<add/SPA=xxx'cr'
>add/SPA='cr''lf'
<add/SPA?'cr'
>add/SPA=xxx'cr''lf'
Where: xxx = new address
None Command only.
<add/CAL='cr'
>add/CAL='cr''lf'
Calibration to allow system to determine nominal LNA power
consumption, performed at initial installation only.
Note: Not applicable for a TX only system
1 byte Command or Query.
<add/LCS=x'cr'
>add/LCS='cr''lf'
<add/LCS?'cr'
>add/LCS=x'cr''lf'
Where: x = 0 (Off)
1 (On)
1 byte Command or Query.
<add/LFL=x'cr'
>add/LFL='cr''lf'
Response to Command (target to
controller)
REF= (message ok)
REF? (received ok, but invalid arguments
found)
REF* (message ok, but not permitted in
current mode)
SPA= (message ok)
SPA? (received ok, but invalid argument
found)
SPA* (message ok, but not permitted in
current mode)
CAL= (message ok)
CAL? (received ok, but invalid argument
found)
CAL* (message ok, but not permitted in
current mode)
LCS= (message ok)
LCS? (received ok, but invalid argument
found)
LCS* (message ok, but not permitted in
current mode)
LFL= (message ok)
LFL? (received ok, but invalid argument
found)
E-8
Revision 9
MN/KST2000AB.IOM
Query
(Instruction
Code and
qualifier)
REF?
SPA?
n.a.
LCS?
LFL?