Air Inlet Controls - Aarrow Signature Inset 5 Operating & Installation Manual

OPERATING INSTRUCTIONS

AIR INLET CONTROLS

The Aarrow Signature 5 stoves have two air inlet
controls.
The primary air inlet providing under draught to the
base of the fire chamber through the control slider
located under the oval at the base of the fire door.
The air wash system, (secondary air) so called
because its pre-heated high speed air, washes
across the inner face of the door glass, keeping it
clear. This also provides an over draught to the
fuel bed.
PRIMARY AIR
Air enters the appliance through the control on the
bottom of the fire door. The Aarrow Signature has
a single control knob which slides left to right.
Sliding the knob to the right (+), see Fig. 13, will
increase the amount of air intake to the stove. To
decrease, push the slider to the left (-) as in Fig. 14
Fig. 13. Fully Open Position
Fig. 14. Fully Closed Position
Page 24
AIR WASH SYSTEM
The air wash has an internal sliding plate with slots,
housed in a cover plate, and is located above the
fire door. Sliding the control knob to the right as far
as it will go, achieves the fully open position, see
Fig. 15. Sliding it to the left will shut off the air inlet
slots as shown in Fig. 16.
Fig. 15. Air Wash Fully Open Position
Fig. 16. Air Wash Fully Closed Position
Aarrow Signature Inset 5